I assumed that the project was already saved. Place the "DC Simulation" and click "simulate" on the simulation menu. It is located at the right side of the panel. To use it, click the wire label command and click the point on the circuit to be simulated. It means that it is the part of the circuit that must be visualize through simulation. The "wire label" command will serve as the simulation point. This circuit will be use for the simulation.įor every simulation scheme wire labeling is needed before starting simulation. Otherwise, you can not use DC simulation. If it uses DC voltage or DC current as a source, then DC simulation should be use. To know if the circuits are in DC form, look for the power sources available. This simulation scheme is intended to simulate DC circuits. If the users will master on it, they can also do the same thing for other simulation scheme. Why I only focus on these? Because these are the common and fundamental simulation scheme. QUCS available simulation schemeįor this tutorial, I will explain how to use these common simulation scheme. This tutorial will be a guide for users who have difficulty in using its simulation. ![]() I read the QUCS help system in its help section, but I did not fully understand, it was not fully stated in details. To my experience, I took time before I fully understand QUCS process of simulation. There are many pre-defined settings before starting. Others also just click "simulate" to start. Some software used "Play" button to start simulation. As for me, simulation in QUCS is very different from other software. This tutorial aims for the users of QUCS circuit simulator on how does its simulation works. I encourage to try other simulator software see the differences)
0 Comments
Leave a Reply. |